WE ARE COMMITTED TO THE DEVELOPMENT OF QUALITY
AFTERMARKET AUTOMOTIVE PRODUCTS.
Bring you quality products since 1990
1024 X 768 RESOLUTION IS REQUIRED TO PROPERLY VIEW THIS WEB PAGE
Our products are proudly made from steel purchased in the USA!
March 19 2011
© Copyright 2011 by Mercado Industries
All items shown are patent pending.
OFFICIAL WEB SITE FOR
C4 MOLDING PROTECTION KIT
The C4 molding kit is made from the same innovative clear polymer as the C4 shield Tech and
when applied, will protect your painted 84 to 96 moldings from annoying door dings, paint chips, scratching and other damage, saving money in costly paint repairs.
- Made from a innovative clear polymer
- easy to apply
- Will protect your C4's moldings from costly paint damage
- Maintenance free
- Will not peel off or yellow
C-4 MOLDING PROTECTION KIT
A full set of color
instructions can be found on our website at www.c4dhr.com
Thank-you for the purchase of our new C-4 MOLDING PROTECTION KIT product. When installed correctly this product will keep your moldings protected and looking new for many years to come.
Please follow the
installation and care instructions exactly to insure you get the maximum usage
and benefits from the C-4 MOLDING PROTECTION KIT Product.
TOOLS AND ADDITIONAL ITEMS REQUIRED
1) Hobby knife or X-acto knife
2) A dry cloth
Application fluid (Must be used in the application of the film)
Application fluid (Must be used in the application of the film) (sold separately)
4) Rubbing alcohol
5) Installation tool.
INSTALLATION TIME - 1 hour
Using the alcohol, clean the moldings removing any dirt or residue. At this stage. repair any stone chips or scratches.
Group the molding protection strips into groups : 2 doors, 2 rear molding (behind door) and 2 front panel.
It is a good idea to start with the smaller pieces since they are easier to apply and then move up to the larger pieces.
Using the application fluid spray the molding. The application fluid is designed to delay the adhesion process, so that you can position and re-position the clear film until you get it right. (WARNING: DO NOT ATTEMPT TO APPLY THE STRIPS WITHOUT THE APPLICATION FLUID.)
Remove one corner of the the clear molding strip from its backing and place it on either the far right side or left side of the molding. Insure that the strip is flush and straight with the bottom of the molding. Then remove the remaining backing as you position and run the strip along the molding. (Handle the adhesive backing as little as possible)
With the strip applied, using a light cloth or your finger, gently press the strip to work out and remove the fluid bubbles from under the strip. ( this must be done before the application fluid begins to dry. (Within 5 minutes Max.)
Using the plastic application tool, firmly press down the film at the top of the molding. Insure that no fluid bubbles are trapped under the film.
Once the strips have been applied to the door moldings, place a small piece of the strip backing underneath the strip overhang on either side of the door moldings. Using a black marker, trace the outline of the moldings edge. Use the X-acto knife to carefully trim off the excess film. (Note only apply enough light pressure to cut through the film and not the backing paper. If you wish, position a piece of cardboard of plastic behind the backing paper for extra paint protection while cutting.)
Once the the film trimming is complete, proceed to to remove any additional air bubbles.
Once the air bubbles are removed, allow the film will for the next 12 hours. (Caution: Do not disturb the film,
or expose it to water during the curing process.
CARE OF THE C-4 C4 MOLDING PROTECTION KIT
Copyright by MERCADO INDUSTRIES © 2009